Samsung ET-WV525 User Manual page 52

In the next section, the user can configure the more advanced wireless settings for the 5GHz frequency band.
The following parameters can be configured:
Wireless Band:
Transmit Power:
Beacon Interval:
RTS Threshold:
Fragmentation:
DTIM Interval:
Preamble Type:
Short Guard Interval:
Click on the Save Settings button to accept the changes made.
Click on the Don't Save Settings button to discard the changes made.
S W R
AMSUNG IRELESS OUTER
Here the user can view the wireless frequency band being configured. In the case 5GHz.
This option sets the transmit power of the antennas.
Beacons are packets sent by an Access Point to synchronize a wireless network. Specify a
value. 100 is the default setting and is recommended.
Here the user can enter the RTS threshold value used. This value should remain at its
default setting of 2346. If inconsistent data flow is a problem, only a minor modification
should be made.
The fragmentation threshold, which is specified in bytes, determines whether packets will
be fragmented. Packets exceeding the 2346 byte setting will be fragmented before trans-
mission. 2346 is the default setting.
Here the user can enter the DTIM Interval value. Delivery Traffic Indication Message
(DTIM) is a countdown informing clients of the next window for listening to broadcast and
multicast messages. The default settings is 1.
Use the radio buttons to specify whether the Router should use the Short Preamble or
Long Preamble type. The preamble type defines the length of the CRC (Cyclic Redun-
dancy Check) block for communication between the Router and roaming wireless adapt-
ers.
Check this box to reduce the guard interval time therefore increasing the data capacity.
However, it's less reliable and may create higher data loss.
U M
SER ANUAL
P 52
AGE