Using Windows Vista - Samsung ET-WV525 User Manual

Windows Vista ® users may use the built-in wireless utility. If you are using another company's utility or Windows
please refer to the user manual of your wireless adapter for help with connecting to a wireless network. Most utilities will have
a "site survey" option similar to the Windows Vista
If you receive the Wireless Networks Detected bubble, click on
the center of the bubble to access the utility or right-click on
the wireless computer icon in your system tray (lower-right
corner next to the time).
Select Connect to a network.
The utility will display any available wireless networks in your
area.
Click on a network (displayed using the SSID) and click the
Connect button.
If you get a good signal but cannot access the Internet, check
you TCP/IP settings for your wireless adapter. Refer to the
Networking Basics section in this manual for more informa-
tion.
It is recommended to enable wireless security (WPA/WPA2) on your wireless router or access point before configuring your
wireless adapter. If you are joining an existing network, you will need to know the security key or passphrase being used.
1. Open the Windows Vista
on the wireless computer icon in your system tray (lower right
corner of screen). Select Connect to a network.
2. Highlight the wireless network (SSID) you would like to
connect to and click Connect.
S W R
AMSUNG IRELESS OUTER
U
SING
® utility as seen below.
Wireless Utility by right-clicking
®
U M
SER ANUAL
W V
®
INDOWS ISTA
3. Enter the same security key or passphrase that is on your
router and click Connect.
It may take 20-30 seconds to connect to the wireless network.
If the connection fails, please verify that the security settings
are correct. The key or passphrase must be exactly the same
as on the wireless router.
® 2000,
P 100
AGE