Table of Contents
Advertisement
HYDRAULIC OPERATING INSTRUCTIONS
Fig.3
Jaw Positioning:
Once all plumbing is set up, it time to position jaws for hydraulic clamping.
1. Position jaws less than 1/4 inch from the part being clamped as is
shown in figure 3 above. This is done manually by putting the handle
onto the hex end and turning the screw until the jaws are in position.
2. Make sure the jaws are less than 1/4 inch from the part since the
hydraulic unit has only a 1/4 inch stroke.
3. The vise is now ready to have the hydraulics engaged for clamping
the part.
For basic hydraulic set-up instructions, go to the next page (pg. 7)
HYDRAULIC SET-UP
6
Advertisement
Table of Contents
