Table of Contents
Advertisement
7.
Tip the jaw so the front of the jaw (the side with the jaw plate) is on the
vise bed. Lower the jaw on to the bed so that the segment contacts the
hook part of the nut and rest the jaw on to the vise bed.
8.
Tighten the setscrew to firmly contact the nut. Back off the setscrew ¼
turn (approx.).
Note: DO NOT leave the setscrew tightened firmly to the nut as this may
cause improper operation. The movable jaw is designed to move slightly
(pivot side to side) so maximum jaw plate contact is maintained when
clamping out-of-parallel, sawed, or cast parts.
9.
Your vise is now ready for use. Open and close your vise to check
for proper operation. Center the part to be clamped in the vise and close.
Your parts should be centered from side to side to ensure proper
clamping.
Fig.13
Jaw
Plate
Stationary
Jaw
Segment
(Half Moon)
Screw
MAINTENANCE SCHEDULE
Movable
Jaw
Screw Brush Seals
Socket Head Set
Screw Location
22
Advertisement
Table of Contents
