Table of Contents
Advertisement
SURFACE MOUNT USING SINE KEYS
Mounting the new 3600H can be done by the use our new sine keys as
well as our standard keys. The fixture keys are available in several different
sizes that are listed on our website at www.kurtworkholding.com. The keys
are sold in sets of 2 per package.
English Mounting:
The 3600H can be properly located using the two English sine key holes
indicated by the Y's in figure 5 above or by using a standard 11/16 fixture
key in the key way. The 3600H can be bolted down using the two 1/2" bolt
holes indicated in figure 5 above by OO. The 3600H vise can also be
mounted using the 4 bolt slots on the sides of the vise as well.
Metric Mounting:
The 3600H can be properly located using the two Metric sine key holes
indicated by the X's in figure 5 above.
PROPER CHIP GUARD INSTALLATION AND USAGE
Table of Contents
Introduction .................................................................................................................3
Fig.9
Setup Instructions......................................................................................................4
Operating Instructions .........................................................................................5-7
DX6 Parts List ...............................................................................................................8
DX6 Mechanical Drawing ........................................................................................9
Maintenance Schedule....................................................................................10-12
Troubleshooting Tips ............................................................................................. 13
CAUTION:
Is used when your action or lack of action may cause serious
CAUTION:
injury.
Chip Guard stock shown above is provided to keep chips from
the nut and screw assembly and must be cut and deburred to
meet your application and safety needs.
Example: Part plus 1 inch = Length of Chip Guard.
Note:
Remove Chip Guard
cause injury.
15
stock. If left uncut, the excess material could
OPERATING INSTRUCTIONS
Advertisement
Table of Contents
