Canon TX-3100 Online Manual page 100

• • Be careful not to pinch your fingers between the Roll Holder shaft and the guide grooves (B) when
loading the roll paper.
Important
• • If the leading edge of the roll paper is secured with tape or a paper band so that it will not unravel,
remove the tape or paper band before loading the roll paper into the roll holder slot.
If you load the paper into the roll holder slot with the leading edge secured, only part of the roll
paper is fed to the paper feed slot, resulting in damage to the roll paper.
• • If the leading edge of the roll paper is cut crooked or folded, it may not be fed correctly. Cut the
leading edge of the roll paper with scissors or the like and straighten it.
• • Load the roll paper so that it is not loaded in the opposite direction.
• Make sure there is no slack in the roll paper, and then load it. •
• • Depending on the surrounding environment, the leading edge of roll paper is stuck because of
static electricity or humidity so that the roll paper may not be able to be fed correctly. In this case,
set Roll paper auto feed to Disable, and then feed the roll paper.
• • If the roll paper is decentered, it may not be able to be fed correctly. In this case, set Roll paper
auto feed to Disable, and then feed the roll paper.
• • When Roll paper auto feed is Enable and if you attach the roll holder without the roll paper
loaded on the roll holder, Preparing to feed the paper... appears on the operation panel. In this
case, press the Stop button on the operation panel to cancel feeding.
Note
• For the procedure for attaching the roll paper to the Roll Holder, see •
Holder."
• When selecting Enable in Roll paper auto feed. •
Go to step 4.
• When selecting Disable in Roll paper auto feed. •
Pull out roll paper evenly, insert leading edge between roll paper and arrows (A) directly beneath
it, and feed roll paper until you hear a sound.
100
"Loading Rolls on the Roll