Commissioning; Oil Supply - ABB HT608016 Operation Manual

Operation Manual / A170-M.. - A175-M..
4 Commissioning / 4.1 Oil supply
4

Commissioning

4.1

Oil supply

4.1.1 Introduction
In all operating states, a functioning and carefully executed oil supply is an important pre-
requisite for trouble-free operation of the turbocharger.
The lubrication of the turbocharger is usually carried out with oil from the engine oil circula-
tion.
Comply with the enginebuilder's specifications regarding the selection of lubricating oil
u
and the oil change intervals.
For more information on the oil supply, refer to Chapter
4.1.2 Pre-lubrication and post-lubrication
The pre-lubrication time is at least 2 minutes.
The post-lubrication time is 10 minutes.
If the engine is operated in idle mode 10 minutes before stopping, no additional post-lubric-
ation is required.
4.1.3 Oil filtering
Filtering of the lubricating oil with a filter mesh width of ≤ 0.050 mm is sufficient for the tur-
bocharger.
4.1.4 Oil pressure
Comply precisely with the oil pressure before the turbocharger for trouble-free operation.
© Copyright 2021 ABB. All rights reserved.
Oil pressure, oil temperature
HZTL4033_EN
→41.
Rev.H July 2021