Fig. 14: Loosening The Clamping Nut - ABB HT608016 Operation Manual

Operation Manual / A170-M.. - A175-M..
3 Removal and installation / 3.2 Removing the turbocharger
3.2.1 Loosening the clamping nut
CAUTION
Incorrect procedure can make loosening impossible
If individual pressure screws are fully relieved, the pressure screws can be-
come compressed, making it impossible to loosen them.
Comply with the following steps for loosening the pressure screws.
u
CAUTION
Do not clean pressure screws
The pressure screws are equipped with a permanent sliding layer that must
not be removed. In case of non-compliance, it cannot be ensured that the
necessary tension force is reached.
Do not clean pressure screws.
u
Do not lubricate pressure screws.
u
If a screw jams, the previously loosened screw must be tightened again a little.
Fig. 14: Loosening the clamping nut
1. Working in a circle, break loose each pressure screw (≤ 20°).
2. Working in a circle, loosen each pressure screw by 45° in 4 rounds.
3. In 1 to 5 rounds, loosen each pressure screw by 90° in circular order until all pressure
screws have been relieved.
Unscrew and remove the clamping nut by hand.
u
© Copyright 2021 ABB. All rights reserved. HZTL4033_EN Rev.H July 2021