Advertisement
Available languages
Available languages
You can change the auxiliary functions, speed and temperature settings without stopping the
programme flow while the programme is running. To do this, the change you are going to make must be
something that will be carried out after the programme step that is running. If the change is not suitable,
relevant lights will flash 3 times.
C
If the machine does not proceed to the spinning step, the Rinse Hold function might be active or the
automatic unbalanced load detection system might be activated due to the unbalanced distribution of the
laundry in the machine.
4.3.14 Loading door lock
There is a locking system on the loading door of the machine that prevents opening of the loading door
in cases when the water level is unsuitable.
Loading door light will start flashing when the machine is switched to Pause mode. The machine checks
the level of the water inside. If the level is suitable, the loading door light will turn off and the loading
door can be opened within 1-2 minutes.
If the level is unsuitable, the loading door light will remain on and the loading door cannot be
opened. If you are obliged to open the loading door while the Loading Door light is on, you
must cancel the current programme. See "Cancelling the programme"
4.3.15 Changing the selections after programme has started
Switching the machine to pause mode
Press the Start/Pause to switch the machine to pause mode while a programme is running. The light of
the current programme will flash on the Programme Follow-up indicator, indicating that the machine has
switched to pause mode.
Also, when the loading door is ready to be opened, the Loading Door light will turn off in addition to the
programme step light.
Changing the auxiliary function, speed and temperature
Depending on the step the programme has reached, you can cancel or select auxiliary functions. See
"Auxiliary function selection".
You can also change the speed and temperature settings. See "Spin speed selection" and "Temperature
selection".
C
If no change is allowed, the relevant light will flash 3 times.
Adding and removing laundry
1. Press the "Start/Pause" button to pause the machine. The programme follow-up light of the
relevant step during which the machine was switched into the pause mode will flash.
2. Wait until the Loading Door can be opened.
3. Open the loading door and add or take out laundry.
4. Close the loading door.
5. Make changes in auxiliary functions, temperature and speed settings if necessary.
6. Press the "Start/Pause" button to start the machine.
50 / EN
Advertisement
