Table of Contents
Advertisement
d.
When the call is ended, it will display "Call end", and you can press [PTT]
to respond the call.
Making a Call
5.10
Method 1: from the Channel switch.
Turn the channel switch to choose a programmed channel.
Method 2: from the Talk Group.
Turn the channel switch to choose a programmed channel;
(1)
Press
(exit) key to enter the TG List, press the
(2)
choose a TG.
Method 3: from the keypad.
Turn the channel switch to choose a programmed channel.
(1)
Press
(Menu) key to Talk Group, press select to enter TG.
(2)
Press
/
(3)
Input the ID number by keypad, press
(4)
Private DMR ID.
Hold the radio vertical 2.5-5cm from your mouth, press the [PTT] key to
start the call, the red LED lights up, the receiver ID/name/city/state/country/
call type and call out icon will be display on the LCD.
Release [PTT] key to receive the reply.
Monitor
5.11
In standby, press the [PF2] key to enter Monitor. When receiving matched
carrier but the signaling / ID is unmatched or the signal is too weak, this
function allows monitor the weak signal and signal with unmatched ID.
Press the [PF2] key again to shut off speaker and return to standby.
» When in analog mode, if no signal, it will emit noise when press the
Monitor Key. ** The Rx icon is seen when monitor is activated.
Emergency Alarm
5.12
Press Emergency Alarm key [PF3] to turn alarm function, then press this
key again to return.
Man Down Alarm
5.13
a.
Press
(Menu) to enter main Menu, press
Select Radio Set, press, press
b.
c.
Select Man Down On to turn on the function.
15
5. BASIC OPERATIONS
key to Manual Dial, press Select.
Digital DMR and Analog UHF/VHF Two Way Radio
key to switch group ID or
/
/
key to Man Down.
/
key to
key to Settings.
Hide quick links:
Advertisement
Table of Contents
