Status Indications; Programmed Key - AnyTone AT-D878UV Plus Operating Manual

Status Indications

4.1
The top LED will help you to identify the current radio status.
LED Indication
Flashes Red
Constant Red
Constant Green
Constant Cyan
Flashes Green

Programmed Key

4.2
It is possible to set different functions for [PF1], [PF2], [PF3],
Method 1: In radio Menu - Settings - Radio Set - Key - PF1, PF2, PF3, P1,P2.
Method 2: In PC software - Public - Optional Setting - Key function.
OFF No Function
Volt Check the current battery capacity voltage
Tx Power Switch the power between super high, high, middle and low power.
TalkAround Switch between Talk Around and Repeater mode
Reverse Turn on/off the frequency reverse function.
Digi Encrypt Choose the digital encryption group for digital channel
In Analog mode, send the DTMF/5TONE/2TONE encode. This
Call
function is only valid for analog channel.
VOX Set up the VOX level
VFO / MR Switch between VFO mode and memory channel mode.
Sub channel PTT, press to start the call on sub channel (NOTE: On
Sub PTT
PF1 - PF2 - PF3 Keys Only)
Scan Press the key to start or stop scanning the channels in scan list.
FM Radio FM radio on/off
Alarm Long press the key to start alarm, short press again to exit the alarm.
Record Switch Enable/disable the recording function
Start/stop recording. When stop recording, the radio will remind repeat
Record
or send the record.
SMS In digital mode, press to enter into SMS messages
Dial Start the manually dial
GPS Info Check the GPS position information
Monitor Monitor the weak signal or the signal with unmatched ID.
Main CH Switch Choose channel A or channel B as the main channel
Hot Key 1~6 Selects Hot Keys 1-6 Note: Hot key setup details on next page
Digital DMR and Analog UHF/VHF Two Way Radio
4. RADIO OVERVIEW
Status
Low battery voltage
Transmitting
Analog Receiving
Digital Receiving
Scan
, keys.
10