Table of Contents
Advertisement
Displaying and setting the water
hardness
Open the door.
Switch the dishwasher off with the
button, if it is switched on.
Press the programme selector button
in, and whilst holding it in switch
the dishwasher on using the but-
ton.
Keep the programme selector button
pressed in for at least four seconds
until the lower right hand programme
indicator comes on.
If this does not happen, start the pro-
cedure from the beginning again.
Before using for the first time
Press the button twice.
The indicator will flash rapidly twice
at intervals.
The value set for the water hardness is
shown as a figure after in the display
(see chart).
will start flashing in the display.
This is the factory default setting of
15 °d.
Use the programme selector button
to select the value which equates
to your water hardness level.
Each press on the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
21
Advertisement
Table of Contents
