Beef Eater 1200 Series Assembly And Operating Instructions Manual page 25

LOCATING YOUR BARBECUE
Partial Enclosures (Australia Only)
This appliance shall only be used in an above ground, open air
situation with natural ventilation, without stagnant areas, where
gas leakage and products of combustion are rapidly dispersed
by wind and natural convection. Any enclosure in which the
appliance is used shall comply with one of the following:
Within a partial enclosure that
includes an overhead cover and
no more than two walls.
Before proceeding, you need to establish the gas type which
your barbecue will run on, and the style of installation you need.
Natural Gas or LPG/Propane.
Before beginning installation or assembly, check that the gas
type which the barbecue is designed for is correct for the gas
available to you. In most countries the choices are natural gas or
LPG/propane. You will find the gas type label on the side of your
barbecue. If your barbecue uses the incorrect gas type, or if you
are unsure, consult your dealer before going any further. Using
the wrong type of gas for a barbecue is extremely dangerous.
Natural Gas Conversion
Most newly purchased barbecues are made for LPG/propane.
A natural gas conversion kit is available to allow your barbecue
to run on Natural Gas. This kit includes all hoses required for
installation
Within a partial enclosure that includes an overhead cover and more than two
walls, the following shall apply:
• At least 25% of the total wall area is completely open; and
• at least 30% of the remaining wall area is open and unrestricted.
In the case of balconies, at least 20% of the total of the side, back and front wall
areas shall be and remain open and unrestricted.
Any enclosure with walls
on all sides, but at least
one permanent opening
at ground level, and no
overhead cover.
25
LOCATING YOUR BARBECUE