Hdmi extender over single cat.x with direct plug-in receiver (10 pages)
Summary of Contents for GoMax Electronics EX-57VJ
Page 1
TABLE OF CONTENTS EX-57VJ INTRODUCTION ......................... 1 FEATURES ......................... 1 SPECIFICATIONS ......................2 PANEL DESCRIPTIONS ..................... 3 HDMI Extender over Single Cat.X with HDBaseT-Lite, Bi- PACKAGE CONTENTS ...................... 4 directional IR & POC CONNECTION DIAGRAM ....................4 IR PASS-THROUGH ......................5 HDMI PIN DEFINITION .......................
Page 2
60m (198 ft) and makes IR control possible through only single Cat.5/5e/6 cable Equalization Auto including HDMI signals. In addition, EX-57VJ also supports PoC (Power over Cable) which can power both Input TMDS signal 1.2 Volts [peak-to-peak] units from either TX or RX with power supply.
Page 3
5. Power LED: Power indicator LED 6. Link LED: Link indicator LED 7. RJ45: Plug in a Cat-5/5e/6 cable that needs to be linked to the receiving unit EX-57VJ-RX Receiving unit ► EX-57VJ-RX 1. HDMI OUT: Connect to a HDMI display with a HDMI male-male cable 2.
Page 4
4. Connect a Cat-5/5e/6 cable between the transmitting and receiving units. 5. Make sure this Cat-5/5e/6 cable is tightly connected and not loose. 6. Plug in 12V DC power supply unit to the power jack of the receiving unit EX-57VJ-RX or the transmitting unit EX-57VJ-TX.
Page 5
NOTICE WARRANTY The SELLER warrants the EX-57VJ 1x2 HDMI 2.0aSplitter with Built-in& User Adjustable EDID 1. All HDMI over CAT5 transmission distances are measured using Belden 1583A CAT5e 125MHz UTP Management and Audio Extractor free from defects in the material and workmanship for 1 year from cable and ASTRODESIGN Video Signal Generator VG-859C &...
Need help?
Do you have a question about the EX-57VJ and is the answer not in the manual?
Questions and answers