Canon REALiS 4K5020Z User Manual page 97

Special Arrangements
3
In [Side], select [Start position] and use the [ ] / [ ] buttons to move the
start marker to the outer edge of the overlapping area.
Do this for each edge; on the top, bottom, left, and right.
4
Select [Width] and use the [ ] / [ ] buttons to move the end marker to the
inner edge of the overlapping area.
Do this for each edge; on the top, bottom, left, and right.
The area between the starting and ending markers is called the blending area.
Shading is applied to this area, and the brightness is adjusted to match
portions that overlap with other areas. After you complete settings for one
image, do the same thing for the other one to specify the blending area. Adjust
the settings to make the blending area for each image the same.
5
Set [Marker] to [Off].
Start marker
97
Blending area
End marker