Philips HF3329/60 User Manual page 23

G
uiDance anD
environment specified below. The user of the goLITE BLU should make sure it is used in such an environment.
i
mmuniTy
Electrostatic Discharge (ESD)
IEC 61000-4-2
Electrical Fast Transient/Burst
IEC 61000-4-4
Surge
IEC 61000-4-5
Voltage dips, short
interruptions and voltage
variations on power supply
input lines
IEC 61000-4-11
Power frequency (50/60 Hz)
magnetic field
IEC 61000-4-8
NOTE: U is the a.c. mains voltage prior to application of the test level.
T
22
m ' D - e
anufacturer S eclaration lectromaGnetic
T iEC 60601 T
EsT
l
±6 kV contact
±8 kV air
±2 kV for power supply lines
±1 kV for input-output lines
±1 kV differential mode
±2 kV common mode
<5% U
T
(>95% dip in U
40% U
T
(60% dip in U
70% U
T
(30% dip in U
<5% U
T
(>95% dip in U
3 A/m
i : The goLITE BLU is intended for use in the electromagnetic
mmunity
C
EsT omplianCE
EvEl
±6 kV contact
±8 kV air
±2 kV for supply mains
±1 kV for input/output lines
±1 kV differential mode
±2 kV for common mode
<5% U
T
) for 0.5 cycle (>95% dip in U
T
40% U
T
) for 5 cycles (60% dip in U
T
70% U
T
) for 25 cycles (30% dip in U
T
<5% U
T
) for 5 sec (>95% dip in U
T
3 A/m
l E
EvEl lECTromagnETiC
g
uidanCE
Floors should be wood, concrete
or ceramic tile. If floors are covered
with synthetic material, the relative
humidity should be at least 30%.
Mains power quality should be
that of a typical home or hospital
environment.
Mains power quality should be
that of a typical home or hospital
environment.
Mains power quality should be
) for 0.5 cycle that of a typical home or hospital
T
environment. If the user of the goLITE
) for 5 cycles BLU requires continued operation
T
during power mains interruptions, it
) for 25 cycles is recommended that the goLITE BLU
T
be powered from an uninterruptible
) for 5 sec power supply or a battery.
T
Power frequency magnetic fields
should be at levels characteristic of a
typical location in a typical hospital
or home environment.
E -
nvironmEnT