Table of Contents
Advertisement
Pausing a Session
Press the ON/OFF button, or press the MINUS button until the intensity reaches 0% to
pause a timed session. Minutes remaining will still show in the display. Press the ON/OFF
button again to continue the session, or press any of the 4 touch screen buttons to end the
session. If you pause a session while on battery power only, after 5 minutes of inactivity,
the session will end and the goLITE will shut off automatically.
Changing the Intensity
While the light source is on, you can change light intensity by pushing either the PLUS or
MINUS button. You can choose intensity settings in increments of 25%.
Setting the Alarm
The alarm can be set to 3 possible modes: chime only, light only, or both chime and light.
To specify the mode, press the ALARM button. The alarm mode icons will begin to flash.
Press either the PLUS or MINUS button to cycle between the 3 modes. Once you make your
choice, press the ALARM button twice or wait 10 seconds to store your setting.
To set the alarm time, press the ALARM button twice. The alarm time will begin to flash.
Press either the PLUS or MINUS button to set the desired time. Hold down either the PLUS
or MINUS button to cycle through the alarm time quickly. Once finished, press the ALARM
button or wait 10 seconds to store your alarm setting. This setting will then be stored in the
device memory as long as there is backup battery power.
Silencing the Alarm Sound
To turn off the alarm while it is sounding, press any of the 4 touch screen buttons or the
ON/OFF button on the side of the goLITE BLU.
Disabling the Alarm
To disable the alarm, press and hold the ALARM button until the alarm icon and alarm time
disappear.
13
Advertisement
Table of Contents
