Table of Contents
Advertisement
Instructions for Use
To begin using the goLITE BLU, remove the stand from the storage cavity on the back and
place the beveled end into the hole also on the back of the device. The stand is held in
place in both the storage cavity and the hole with magnets.
Turning on the goLITE BLU Display
Push the ON/OFF
button on the side of the device to turn the goLITE BLU display on. To
turn the display off, press and hold the ON/OFF button for 2 seconds. When the device is
on battery power only, after 5 minutes of inactivity, the goLITE will shut off automatically to
preserve battery power.
Setting the Clock
While the goLITE BLU is on, press and hold both the ALARM and TIMER buttons for 2
seconds. The clock display will flash while setting the clock. Press either the PLUS (+) or
MINUS (-) button to adjust the clock. Hold down either the PLUS or MINUS button to cycle
through the clock time quickly. When finished, press either the ALARM or TIMER button, or
wait 10 seconds to exit the clock setting mode. To switch between 12-hour (a.m. & p.m.) or
24-hour time format, press and hold both the TIMER and MINUS buttons for 2 seconds.
Timing a Session
To start a timed session, press the TIMER button. The timer icon and minutes will flash.
Select the desired usage time by pressing either the PLUS or MINUS button. Hold down
either the PLUS or MINUS button to cycle through the clock time quickly. The timer can be
set between 1 and 60 minutes. This setting will then be stored in the device memory. When
the light source is turned on, it will count down from this set time. When it has finished
counting down, the session will end automatically.
Turning on the Light
While the goLITE BLU is on, press and release the ON/OFF button on the side of the device
to turn the light source on or off.
12
Advertisement
Table of Contents
