Weight Display Resolution - A&D SJ-3000WP-BT Instruction Manual

 The switch will tare the scale and subtract the weight to zero as a tare weight
TARE
when the weight is a plus value. In this case the ZERO◄ and NET◄ indicators turn on.
(TARE operation) At the zero point, the net weight display shows the tare weight in
negative, and the ZERO◄ and NET◄ indicators turn on.
(Note: In some countries or areas, the ZERO ◄ indicator will not turn on while
the scale is tared.)
 When the scale is tared, weighing range for net loads is reduced by the amount of the
tare weight.
 When the ZERO operation is performed in the net weight display, the tare operation
previously done is cleared and the NET◄ indicator turns off.
(Note: In some countries or areas, the ZERO operation will not clear the TARE
operation. Press the
the weighing pan.)
Auto power-off function
 If no switch is pressed and the stable indicator is displayed for a certain period of time, the
scale will automatically turn off. See the function setting
to turn off.
 When
function is enabled.
LCD backlight
 The LCD backlight is controlled by the functions
 If no switch is prssed and the weight display continues to be stable for a certain period of
time, the LCD backlight will automatically turn off. The elapsed time to turn off is set by the
function setting
 The function setting

5.3. Weight Display Resolution

The weight display resolution is a ratio of the minimum display to the weighing capacity.
The SJ-WP/-BT series has four types of weight display resolution, as shown below.
Low:
Normal:
High:
Maximum:
The factory setting is the normal resolution. Select the resolution according to your own
application in the function setting
 For details about the minimum display and the weighing capacity,
refer to "14. SPECIFICATIONS".
 The weight display resolution of the Legal for Trade models is fixed. The selection in the
function setting
 In the counting mode, the scale works with the maximum resolution regardless of the
weight display resolution selected in the function setting
TARE
or is displayed (refer to
. The backlight always on or off is also selectable.
adjusts the brightness of the backlight.
1/3,000
1/6,000 or 1/7,500 (depending on the weighing capacity)
1/12,000 or 1/15,000 (depending on the weighing capacity)
1/30,000
is not available.
switch after zeroing the scale with nothing on
12.3. Error Codes "), the auto power-off
"
.
8
to set the elapsed time
and .
.