Table of Contents
Advertisement
RUGGEDCOM RS920W
Installation Guide
Figure 7: Terminal Block Wiring – Single DC Power Supply Inputs
1. Positive Terminal 2. Negative Terminal 3. Surge Ground Terminal 4. Braided Ground Cable
3.
Connect the negative wire from the power source to the negative terminal on the terminal block.
4.
[Optional] If a redundant connection is required, repeat
inputs.
Connecting Low DC Power
2
1
3
4
±
±
Step 2
and
Step 3
to connect the secondary power
Chapter 2
Installing the Device
13
Advertisement
Table of Contents
