Electrolux EOD6P40X User Manual page 27

1. Wipe out the cavity with a wet, soft
cloth.
2. Clean the inner side of the door with
hot water, so that the residues do not
burn from the hot air.
3. Set the Pyrolysis function. Refer to
"Daily use" chapter, "Oven
Functions".
4. When flashes, turn the knob for
the temperature to set the pyrolysis
duration:
Option
P1
P2
After 2 seconds the pyrolysis starts.
You can use the END function to delay
the start of the cleaning.
During the pyrolysis the oven lamp is off.
5. When the oven is at the set
temperature, the door locks. The
display shows
heat indicator until the door unlocks.
To stop pyrolysis before it is
completed, turn the knob for the oven
functions to the off position.
6. When pyrolysis is completed, the
display shows the time of day. The
oven door stays locked.
7. When the oven is cool again, the
door unlocks.
11.6 Cleaning reminder
To remind you that the pyrolysis is
necessary, PYR flashes in the display for
10 seconds after each activation and
deactivation of the oven.
Description
Light clean‐
ing. Duration:
1 h 30 min.
Normal
cleaning. Du‐
ration: 2 h 30
min.
and the bars of the
The cleaning reminder
goes out:
• after the end of the
pyrolysis.
• if you press
at the same time while
PYR flashes in the
display.
11.7 Removing and installing
door
The oven door has three glass panels.
You can remove the oven door and the
internal glass panels to clean them.
Read the whole "Removing and installing
door" instruction before you remove the
glass panels.
The oven door may close if
you try to remove the glass
panels before you remove
the oven door.
CAUTION!
Do not use the oven without
the glass panels.
1. Open the door fully and hold both
hinges.
2. Lift and turn the levers fully on both
hinges.
ENGLISH 27
and