Using The Accessories - Electrolux EOD6P40X User Manual

12 www.electrolux.com
7.4 Setting the END function
1. Set a heating function.
2. Press
starts to flash.
3. Turn the knob for the temperature to
set the hours and press
confirm. Turn the knob for the
temperature to set the minutes and
press
At the set End time the signal sounds for
2 minutes.
the display. The oven turns off
automatically.
4. Press any button or open the oven
door to stop the signal.
5. Turn the knob for the heating
functions to the off position.
7.5 Setting the TIME DELAY
function
1. Set a heating function.
2. Press
starts to flash.
3. Turn the knob for the temperature to
set the minutes for DURATION time
and press
knob for the temperature to set the
hours for DURATION time and press
to confirm.
The display shows flashing
4. Turn the knob for the temperature to
set the hours for END time and press
to confirm. Turn the knob for the
temperature to set the minutes for

8. USING THE ACCESSORIES

WARNING!
Refer to Safety chapters.
8.1 Inserting the accessories
Wire shelf:
Push the shelf between the guide bars of
the shelf support and make sure that the
feet point down.
again and again until
to
to confirm.
and time setting flash in
again and again until
to confirm. Turn the
.
END time and press
The display shows
set temperature.
Oven turns on automatically later on,
works for the set DURATION time and
stops at the set END time.
At the set END time the signal sounds for
2 minutes. and time setting flash in
the display. The oven turns off.
5. Press any button or open the oven
door to stop the signal.
6. Turn the knob for the heating
functions to the off position.
7.6 Setting the MINUTE
MINDER
Minute minder can be both set when the
oven is turned on and off.
1. Press again and again until
and "00" flash in the display.
2. Turn the knob for the temperature to
set the seconds and than the
minutes.
When the time you set is longer than
60 minutes,
3. Set the hours.
4. The MINUTE MINDER starts
automatically after 5 seconds.
After 90% of the set time the signal
sounds.
5. When the set time ends the signal
sounds for 2 minutes. "00:00" and
flash in the display. Press any button
to stop the signal.
Deep pan:
to confirm.
and the
flash in the display.