Table of Contents
Advertisement
Mounting the lens
Image 2–18
2.
Once the desired position has been reached, tighten the vertical shifting screws (2 and 3).
3.
Fine-tune the tilt of the projected image, using screw 5. Using this method, you can adjust ±7.5°.
Image 2–19
Tip: Turning screw 5 clockwise will tilt the image counterclockwise. Turning the screws
counterclockwise will tilt the image clockwise.
Image 2–20
4.
Fine-tune the focus of the projected image vertically, using points A and B on the following image as
reference points. The resolution/balance between both points should be the same.
•
Use the focus software feature to help focus the image.
•
Use adjustment screw 6 to help focus the image.
•
Use the focus ring at the end of the lens to help focus the image.
•
If necessary, loosen screws 2 and 3 a bit to push the lens a bit upward or downward to spot any
variation in image quality.
18
R5914435. /00
UST-Lens for G100 series
Advertisement
Table of Contents
