Table of Contents
Advertisement
Image 2–3
Image 2–4
A
reference marking
3.
Rotate the motor housing until the chosen marker on the housing corresponds with the reference marking
on the lens body (steps of 30°). See if the mounting holes matches the holes in the lens body.
E.g. if you want to project to the left, then turn the motor housing until the left marking on the motor
housing corresponds with the reference marking on the lens housing.
A
Image 2–5
A
Project LEFT
B
Project RIGHT (not used on G100)
C
Project UP
4.
Slide the motor housing back to the front of the lens to re-engage focusing gear and motor gear.
5.
Drive in 6 new Allen screws with glue (screws are delivered with the kit). These screws can be multiple
times reused. The turned out old screws can be thrown away.
Use again a tool with a long shaft (Allen wrench 2 mm, delivered with the kit).
The lens is ready to be mounted on the projector.
Slide range: 5mm max
Motor unit
3
A
2
B
R5914435. /00
Mounting the lens
Disengage
Motor gear
Focusing gear
C
UST-Lens for G100 series
11
Advertisement
Table of Contents
