Table of Contents
Advertisement
Image 2–8
2.3 When mounting the lens without the support
When to use the safety cable
While it is strongly recommended to use the specifically designed mounting support for this lens in
combination with this lens, it is not mandatory.
When mounting the UST lens in a projector without using the mounting support (not recommended), it is
strongly advised to use the safety cable set provided by Barco instead. Failing to use either the correct type of
safety cable or the mounting support may damage the lens and/or projector.
How to prepare the lens with the safety cable
1.
Stick 3 to 4 clips on the surface of the lens body (1).
2.
Snap the first loop end of the safety cable into one of the clips.
2
1
Image 2–9
3.
Slide the rest of the cable around the lens. Click the cable into every clip it passes in the loop.
4.
Slide the cable through the loop end at the beginning of the cable (2).
5.
Install an U-bolt on the lens holder with the open ends oriented outwards (3). Make sure that both a part of
the loop end and the outgoing part of the safety cable are placed in the enclosure.
6.
Close the U-bolt and tighten it.
3
R5914435. /00
Mounting the lens
UST-Lens for G100 series
13
Advertisement
Table of Contents
