Table of Contents
Advertisement
Mounting the lens
2.1 Adapting the lens for the projecting position
Required tools
Allen wrench with long shaft 2 mm
How to adapt
1.
Place the lens on a table. Turn out the 6 screws (1). Use an Allen key with a long shaft so that you do not
damage the screw head. These screws will not be reused.
Note: Always use the correct tool (delivered with the kit) to avoid damage to the screw heads !
Image 2–1
Image 2–2
2.
Slide the motor housing a few mm to the backside of the lens (2) to disengage focusing gear and motor
gear.
10
R5914435. /00
UST-Lens for G100 series
1
1
Advertisement
Table of Contents
