Advertisement
Quick Links
Kit Instructions
™
LineLazer
Kit for Converting to a High
Production (HP) Auto Sprayer
Kit 25A527 for HP Auto upgrade with Laser
Kit 25A932 for HP Auto upgrade without Laser
For the application of line striping materials.
For professional use only.
Not for use in explosive atmospheres.
Important Safety Instructions
Read all warnings and instructions in this manual and in related manuals.
Be familiar with the controls and the proper usage of the equipment.
Save these instructions.
HP Auto Switch
25A490 Kit
Single Solenoid
25A495 Battery and
25A530 Laser Kit
Charging Board Kit
(25A527 Kit only)
25A494 HP Auto
Control Board
ti28741
3A3455A
EN
Advertisement
Related Manuals for Graco LineLazer 25A527
Summary of Contents for Graco LineLazer 25A527
- Page 1 Kit Instructions ™ LineLazer Kit for Converting to a High 3A3455A Production (HP) Auto Sprayer Kit 25A527 for HP Auto upgrade with Laser Kit 25A932 for HP Auto upgrade without Laser For the application of line striping materials. For professional use only. Not for use in explosive atmospheres.
-
Page 2: Pressure Relief Procedure
Pressure Relief Procedure Pressure Relief Procedure 2. Set pump switch to OFF. Turn engine OFF. 3. Turn pressure control to lowest setting. Trigger all guns to relieve pressure. 4. Engage all gun trigger locks. Turn prime valve down. SKIN INJECTION HAZARD This equipment stays pressurized until pressure is 5. - Page 3 Installation 7. Insert switch wires (21) into clips (25) and into oval 10. Install new battery charging board, Kit 25A495, hole. included in Kit 25A526. ti28479a 8. Install solenoid bracket, solenoid Kit 25A490, and solenoid cover. Route solenoid wires up through the upright channel to the control box.
- Page 4 Installation 12. For LineLazer V 3900 or 5900, connect the other wires to the main board in the order shown. CONTROL BOARD (24Y310 - STANDARD) (24Y311 - HP AUTO) POTENTIOMETER WHITE BLACK BLACK PROGRAMMING PORT BLACK FUSE HOLDER CHARGER BOARD (24Y443 - HP AUTO) BLACK 30A AUTOMOTIVE FUSE...
- Page 5 Installation 13. For LineLazer V 200HS, connect the other wires to the main board in the order shown. WHITE/YELLOW YELLOW CONTROL BOARD (24Y310 - STANDARD) (24Y311 - HP AUTO) WHITE/RED BLACK GUN 1 BLACK GUN 2 CHARGER BOARD (24Y443 - HP AUTO) FUSE HOLDER REGULAR ATO ti28485a...
- Page 6 Installation 14. Bundle and cable-tie the two gray wires on the right 20. Connect battery leads and install cover. side of the main board as shown. 15. Do not cable-tie the white solenoid wires. 16. Bundle and cable-tie the wires on the left side of the main board as shown.
- Page 7 Installation 22. Start engine and calibrate distance sensor per the 24. Select 3900, 5900 or 200HS to match your operation manual (3900, 5900 operation 3A3388; LineLazer. 200HS operation 3A3426). 25. Set time, date, and units to complete the installation. 23. After calibration, use the arrows to select the set- tings screen.
- Page 8 This manual contains English. MM 3A3455 Graco Headquarters: Minneapolis International Offices: Belgium, China, Japan, Korea GRACO INC. AND SUBSIDIARIES • P.O. BOX 1441 • MINNEAPOLIS MN 55440-1441 • USA Copyright 2016, Graco Inc. All Graco manufacturing locations are registered to ISO 9001. www.graco.com...