Associating Modules To Channels - Intermatic HA07 Instructions Manual

Associating Modules to Channels

1. (See Fig 9a) On the remote controller, simultaneously
press and hold the channel ON and OFF buttons of the
desired channel. LEARN will be displayed. (Note:
Learning mode will time out after 10 seconds. If this
happens, ON and OFF buttons have to be pressed
again). Release the ON and OFF buttons after
"LEARN" appears in the display.
2. (See Fig 9b) Press and hold the INCLUDE button.
INCL will appear on the screen.
3. (See Fig 9c) CONTINUTE TO HOLD THE INCLUDE
BUTTON. You may now set a scene for your channel
by pressing the PROGRAM button on the module until
you reach your desired light-level setting. Possible
settings are FULL ON, FULL OFF or DIM LEVEL.
Setting different light levels for different modules allows
you to create "scenes" for each channel.
NOTE: Only HA03 Lamp Module and HA06 In-Wall
Switch/Dimmer have dimming capabilities.
4. Release the INCLUDE button on the remote controller.
After you release the INCLUDE button, the controller
will store the current light-level and SUCCESSFUL will
display on the controller for 2 seconds and the module
LED will flash for 2 seconds.
5. To add additional devices, repeat steps 1 – 4.
Page 16 of 35