Setting Astronomic Function
NOTE: If you do not want to use the Astronomic function, you
can bypass SETUP mode by pressing the MODE button until
program (PGM) mode is displayed. (See Fig. 6)
1. The default SUNUP times for this zone will be flashing.
Press ENTER to accept.
2. If the time is not correct, or if you would like to
customize the SUNUP time, press + or - to enter the
desired time and press ENTER.
3. (See Fig 7) SUNSET times for this zone will be flashing.
Press ENTER to accept.
4. If the time is not correct, or to customize this time, press
+ or - to enter the desired time and press ENTER.
Fig 6 – SUNUP default time may be different than shown above.
Page 13 of 35