Advice For The Installer - CDA SV 980 Installation, Use And Maintenance Manual

27

ADVICE FOR THE INSTALLER

Important
Appliance installation and maintenance must only be carried out by QUALIFIED TECHNICIANS
and in compliance with the local safety standards.
• Failure to observe this rule will invalidate the warranty.
• Always disconnect the appliance from the electrical supply before carrying out any maintenance
operations or repairs.
• The walls surrounding the oven must be made of heat-resistant material.
• Taking care NOT to lift the oven by the door handle.
The oven can be fitted in standard units, width 90 cm and depth 60 cm.
Installation requires a compartment as illustrated in figures 16 and 17.
On the lower side, the oven must lay on a surface that support the oven's weight.
WARNING
When correctly installed, your product meets all safety requirements laid down for this type
of product category.
However special care should be taken around the rear or the underneath of the appliance as
these areas are not designed orintended to be touched and may contain sharp or rough edges,
that may cause injury.