3. Environment and Installation
3.6.2 Power Connection
■ Before supplying power to the part feeder, check that the distribution voltage is
the same as the nominal voltage.
■ Never disconnect the power cables when the unit is on. Always turn the machine
off and then cut the power.
CAUTION
■ Use PELV (protected extra-low voltage) nominal voltage.
■ Unplug the main power plug when plugging / unplugging the cord.
Connector type (on IF-80 side): M16, 5 Poles, male
■ In case of all functions working simultaneously (vibration, backlight, hopper), the
NOTE
current increases to 6A
30
Pin
Signal description
(1)
24VDC PELV S-Power
(2)
0V GND S-Power
(3)
24VDC PELV Power
(4)
0V GND Power
(5)
EARTH
Figure 3-6: Power connection
Part Feeding 7.0 IF-80 Rev.3