Epson Part Feeding 7.0 IF-80 Manual page 12

1. Safety
■
The LEDs used are class 0 according to the norm EN 62471. It is the responsibility of
customers to document their own application and instruct employees on procedures to
limit exposure to LED radiation. The following prevention agent can be suggested:
A Interpose, insofar as the job allows, a high pass filter at x nm depending on the color
B When the implementation of the foregoing is not possible, provide workers with
WARNING
C Prohibit or limit as possible direct access to the source. (exposure in the axis of
D Establish a security perimeter to prevent operators from approaching the source at
E In all cases, ensure that the means used properly mitigate exposure variables
■ Temperature
The active elements in the IF-80 make the surfaces shown in the Figure 1-2 heats up to
40°C in normal use. This temperature can nevertheless increase to 55°C in extreme use.
It is the responsibility of customers to document their own application and instruct
employees on procedures to avoid contact with these surfaces.
CAUTION
6
(see 2.6.5 Backlight) under a fixed or adjustable connection between the source and
the employee.
goggles or face shield suitable for blocking radiation beyond 700nm.
radiation)
distances beyond the nominal ocular hazard recommended by the manufacturer.
(characteristics of screens or goggles to choose based on wavelength which operators
are exposed).
Figure 1-2: Specific warnings
Part Feeding 7.0 IF-80 Rev.3