Epson Part Feeding 7.0 IF-80 Manual page 52

5. Maintenance and Component Replacement
Step 4
Parameters in memory can now be modified from the EPSON RC+, go to the
[Setup]-[System Configuration]-[Controller]-[Part Feeding] page
For more details, refer to Software 2.1 System Configuration.
Step 5
When parameters are defined as desired, replace selector 1 in position (D).
Step 6
Disconnect and reconnect the power cable. (or switch off and switch on the power on the
IF-80.)
The IF-80 will take the parameters defined by the new startup.
Step 7
Replace the cover (B) and screw the 4 screws (A).
Use a torx key size 10. (0.9 N·m)
46 Part Feeding 7.0 IF-80 Rev.3