Accessories - Kärcher B 80 Manual

Fault Remedy
Machine does not move Stand-by. Turn the appliance off and reinsert the Intelligent Key.
Turn the program selection switch to the desired programme.
Only for B 80 W Bp Dose Colruyt: Release the emergency buttons by turning.
Release parking brake.
Check battery; charge it if required.
Make sure that all battery terminals are connected.
Insufficient water quan- Check fresh water level, refill tank if necessary.
tity
Increase the water volume on the regulating knob for water volume.
Unscrew the lock of the fresh water reservoir. Remove and clean the fresh water filter. Insert the filter and screw
in the lock.
Remove the water distribution strip from the cleaning head and clean water canal (only R cleaning head).
Check hoses for blockages; clean if required.
Do not add detergents Increase the water volume to activate the dosing pump.
Check the detergent level
Insufficient vacuum per- Clean the seals between waste water tank and cover and check for tightness, replace if required.
formance
Wastewater reservoir is full; shut off the appliance and empty the wastewater reservoir
Clean protective turbine strainer.
Clean the vacuum lips on the vacuum bar, replace if required
Check suction hose for blockages; clean if required.
Check the suction hose for tightness; replace if required.
Check if the cover on the dirt water discharge hose is closed
Check the setting of the vacuum bar.
Insufficient cleaning re- Check the brushes for wear, replace if required.
sult
Vibrations during clean- Cleaning head has play, open the excenter lever and press the cleaning head all the way against the push han-
ing dle, close the excenter lever.
You might need to use softer brushes.
Brushes do not turn Check if foreign matters block the brushes; remove foreign matter if required.
If over-current switch in the electronics system has been triggered, turn programme selection switch to "OFF".
Afterwards, set it back to the desired programme.
In case of faults that cannot be remedied using the table below please contact the customer service.
Description
Brush roller, red (medium, standard)
Brush roller, white (soft)
Brush roller, orange (high/ low)
Brush roller, green (hard)
Brush roller, black (very hard)
Pad roller shaft
Roller pad, yellow (soft)
Roller pad, red (medium)
Roller pad, green (hard)
22
Faults without display on the console

Accessories

BR appliance B 80 (brush roller accessories)
Part no.: Part no.:
Working width Working
650 mm width 750
mm
6.906-935.0 6.906-936.0 Also for regular cleaning of heavily dirtied
6.906-981.0 6.906-985.0 For polishing and cleaning sensitive floors.
6.906-982.0 6.906-986.0 For scrubbing structured floors (safety tiles,
6.906-983.0 6.906-987.0 For thoroughly cleaning heavily dirtied floors
6.906-984.0 6.906-988.0
4.762-433.0 4.762-434.0 For intake of roller pads.
6.369-454.0 6.369-454.0 For polishing floors.
6.369-456.0 6.369-456.0 For cleaning slightly dirtied floors.
6.369-455.0 6.369-455.0 For cleaning normal to heavily dirtied floors.
EN
Description
floors.
etc.).
and for removing the coating (for e.g. of wax,
acrylate).
9
-
1 2
1 2
1 2
1 2
1 2
1 2
20 96; 106
20 96; 106
20 96; 106