Jinergy JNMP60 Installation Manual page 23

Cut off the straps, remove the top package down and hold on flat
1
floor, as shown in figure 1.
Cut the two longitudinal straps, then carefully cut and remove
2
the cardboard of one short side of the box, as shown in figure 2.
Cut the cardboard, then cut the inner straps around the
3
modules, as showed in figure 3.
Pull slowly out the modules from the back side of the module,
then carry one module with two people，as showed in figure 4.
4
When take off the last eight modules, the outermost module
must be slanted to lean on the other modules (If not may result
in hidden cracks or damage when the module tilted).
Package could be put on the place that the tilt angle is not more
than 17 degrees. When unpacking on non-horizontal place,
5
measures should be needed to protect modules, as showed in
figure 5.
If there are modules left after unpacking, please lay them flat
and repack them.
Note
For details on the storage of scattered components, see the
following page.
4. Suitable for 182 double glass modules
Figure 1
S/N
Cut the packing belt on the outer side of the wooden support and
1
gently remove the wooden support, as shown in figure 1.
Cut off the straps, remove the top package down and hold on flat
2
floor, as shown in figure 2.
Cut the two longitudinal straps, then carefully cut and remove
3
the cardboard of one short side of the box, as shown in figure 3.
Cut the cardboard, then cut the inner straps around the modules,
4
as showed in figure 4.
This document is only for internal use of JINNENG CLEAN ENERGY TECHNOLOGY LTD, and shall not be published or
copied without permission of the company.
Figure 2
Operating Procedure
Figure 3 Figure 4
For the safety of operation,
operators should
anti-cutting gloves and other
labor protection supplies ； Pay
attention to not damage the
modules during the
process.
Figure 5 Figure 6
Control Point
For the safety of operation,
operators should
anti-cutting gloves and other
labor protection supplies； Pay
attention to not damage the
modules during the
process.
wear
cutting
wear
cutting