Jinergy JNMP60 Installation Manual page 2

1 Introduction
1.1 Purpose
This document provides detailed instructions and valuable safety information regarding the
installation, electrical connection and maintenance of the JINNENG CLEAN ENERGY
TECHNOLOGY LTD (Hereinafter referred to as " JINERGY "）Crystalline Photovoltaic modules,
involved module series are as follow Table 1:
Cell Size
158.75
166
182
210
All instructions and mechanical and electrical requirements should be read and understood
before attempting installation.
The installer should conform to all safety precautions in this guide when installing the module.
Keep this guide in a safe place for further reference.
1.2 Limitation of Liability
Because the use of this manual and the conditions or methods of installation, operation, use
and maintenance of photovoltaic (PV) products are beyond JINERGY control, JINERGY does
not accept responsibility and expressly disclaims liability for loss, damage, or expense arising
out of or in any way connected with such installation, operation, use or maintenance. JINERGY
reserves the right to change the manual without prior notice.
1.3 Others
1.3.1 Modules rated for use in this application class may be used in systems operating at greater
than 50V DC or 240W, where general contact access is anticipated. Modules qualified for
safety through IEC 61730-1 and this part of IEC 61730 within this application class are
considered to meet the requirements for safety class II.
1.3.2 Where common grounding hardware (nuts, bolts, star washers, spilt-ring lock washers, flat
washers and the like) is used to attach a listed grounding/bonding device, the attachment
must be made in conformance with the grounding device manufacturer's instructions.
2 Safety
2.1 General Safety
2.1.1 Consult and follow local codes and other applicable laws concerning required permitting as
well as installation & inspection requirements, rules, and regulations.
2.1.2 PV modules should be installed and maintained by qualified personnel.
2.1.3 Use the same performance modules within a given series.
2.1.4 Follow all safety precautions of all components used in the system.
This document is only for internal use of JINNENG CLEAN ENERGY TECHNOLOGY LTD, and shall not be published or
copied without permission of the company.
JNMP60/JNMM60/JNMP72/JNMM72/JNMP120/JNMP144
JNMM120/JNMM144/JNBM120/JNBM144/JNHM120/JNHM144
JNMM108/JNMM144/JNBM144
JNMM120/JNBM120/JNMM132/JNBM132
Table 1
Module Type