Jinergy JNMP60 Installation Manual page 20

If the container is on the ground, the
1
module can be unloading directly.
If the container is on the flatbed
trailer, the module need a landing
2
platform when unloading.
The forklift can loading 3T or more,
raising the module smoothly pull out
3
and keep slow speed when holding
the module.
2. Vertical - container loading
S/N Operating Procedure
If the container is on the ground, the
1
module can be unloading directly.
If the container is on the flatbed
2 trailer, the module need a landing
platform when unloading.
This document is only for internal use of JINNENG CLEAN ENERGY TECHNOLOGY LTD, and shall not be published or
copied without permission of the company.
If the container is not full， the people need to
cut the bandage when unloading(If the
container is full，the bandage is none).
1. Before the forklift operate, add some
buffer articles at the forklift arm to avoid
damaging the module.
2. Box transportation needs to keep
horizontal or tilted to the direction of
forklift.
3. The vertical surface of the forklift arm
should be smooth and there are no
something that sticks out.
4. Start from the short side of the packing
box, reduce modules that are broken.
5. When second transportation, a special
person should be command to carry, and
it is prohibited to damage the packing
box.
6. During operation, the forklift truck
should not hit the pallet including the
pallet wooden pier.
1. Box
horizontal or tilted to the direction of forklift.
2. The vertical surface of the forklift arm
should be smooth and there are no
something that sticks out.
Photo
If the container is not full， the people need to
cut the bandage when unloading(If the
conta iner is full，the bandage is none).
1. Before the forklift operate, add some
buffer articles at the forklift arm to avoid
damaging the module.
2. Box transportation needs to keep
horizontal or tilted to the direction of
forklift.
3. The vertical surface of the forklift arm
should be smooth and there are no
something that sticks out.
transportation needs
Control Point
to keep