Advertisement
Quick Links
Quick Connect Under Sink Stainless-steel Water Filtration System
Instruction
Manual
Model No.: WD-BS08
Inlet
Filter head
Cartridge
Fastening
ring
39.3 inches
3/8'' tubing
Faucet
Quick-connect
Filter housing
fitting
Speci cations
Operating temperature
Working pressure
Flow rate
Feed water requirement
Filter capacity
Precautions
• Please wear a pair of gloves when installing to avoid scratching your hand.
• Do not use it with water that is microbiologically unsafe or of unknown quality without
adequate disinfection.
• For use only with cold water.
• Do not freeze the filter, as this can cause cracking and water leakage.
• Do not allow children under 3 years old to have access to small parts during installation of this
product.
• This installation must comply with all applicable state and local regulations.
• Turn off the water supply while replacing the filter.
Bracket
Outlet
39.3 inches 3/8'' tubing
3/8''-1/2'' Converter
Feed water adapter
3/8''-1/2'' Converter
Teflon tape
Wrench
41-100℉/5-38℃
15-100 psi/100-689 kpa
1.6 gpm/6.0 lpm (tested under 60psi)
Municipal tap water
Up to 1 year/8000 gallons
(Note: Actual life varies according to local water quality.)
Advertisement
Related Manuals for Waterdrop WD-BS08
Summary of Contents for Waterdrop WD-BS08
- Page 1 • Do not freeze the filter, as this can cause cracking and water leakage. • Do not allow children under 3 years old to have access to small parts during installation of this Model No.: WD-BS08 product. • This installation must comply with all applicable state and local regulations.
- Page 2 Installation of the lter system Step 2 Install the Feed Water Adapter (cold water only) 1. Shut off the water supply. Turn on the kitchen faucet to release the water pressure; How to Use the Quick-Connect Fittings (To connect) Note: Make sure the water has stopped running before proceeding to the next step.
- Page 3 Faucet Spout Outlet Faucet Body Inlet Countertop Faucet Stem Cold Mounting Washer Lock clip Filter system Quick-Connect fitting Figure 4 Lock clip Cartridge change instructions Step 1 Remove the Old Cartridge Step 4 Connect Tubing Turn off the water supply to the system. Open faucet to release the pressure and drain the water. 1.
- Page 4 Q: Why didn't the TDS value lower after ltration? A: The main purpose of this Waterdrop filter is not to remove TDS. TDS stands for total dissolved solids, and it is basically composed of inorganic salts and a small amount of organic matter. The filter can remove harmful substances while keeping beneficial trace elements.