Related Manuals for Waterdrop WD-WHF21-PG
Summary of Contents for Waterdrop WD-WHF21-PG
- Page 1 Read this manual before using and keep it for future reference. User Manual 2-Stage Whole House Water Filtration System...
-
Page 3: Table Of Contents
Table of Contents Product Operation and Specifications ..............2 Components List ........................2 Tools Required ........................2 Pre-installation ........................3 Installation ..........................3 Maintenance Instructions ....................6 Filter Change Instructions .....................7 Frequently Asked Questions ..................8 Warranty ..........................9... -
Page 4: Product Operation And Specifications
Product Operation and Speci cations WD-WHF21-PG/WD-WHF21-FG Model Up to 12 GPM Flow Rate 25~90 psi Working Pressure 40-100 ˚F (4 - 38 ˚C) Operating Temperature Municipal tap water Feed Water Requirement Lifetime: 3-6 months Grooved Fit PP Cotton Filter Lifetime: up to 6 months... -
Page 5: Pre-Installation
Parts required (Not Included) (2x) Hex nipples or pipe nipples (2x) Shuto valves (as needed) (2x) Pipe union pressure regulators (as needed) Pre-installation • Turn o the water to your house before beginning the installation. Turn o power to your water heater before installation. Open all plumbing xtures in the house to drain the lines of water and pressure. - Page 6 1. Close the main intake valve. Turn on 1’’ . Brass PEX-A Expansion Barb x 1‘’ MNPT Male Adapter the tap to release the pressure in the pipe. 2. Remark two 1‘’ . Brass PEX-A Expansion Barb x 1‘’ MNPT Male Adapter(not included in the box).
- Page 7 Step 4: Screw the lter housing tightly Tighten the blue lter housing by hand. Then, use supply lter wrench to tighten the blue lter housing. Close Step 5: Slowly turn on the main inlet valve. Turn o the water outlet after the domestic water equipment is able to dispense water.
- Page 8 Screw one end of the external thread into the thread of the 1” MNPT lter bottle and tighten it with a wrench. Refer to the installation steps above for further steps. ¾‘’ . Brass PEX-A Expansion Barb x 1‘’ MNPT male Adapter 2.
-
Page 9: Maintenance Instructions
Maintenance Instructions Your Whole House Water System requires care and cleaning after a period of time. It is recommended that the cartridges be replaced every 6 months depending on the amount of contaminants present in the water supply. If the system has been working properly and the pressure is slowing, it may be time to change the lter cartridge. -
Page 10: Frequently Asked Questions
Note: If there is a sealing ring left by the old lter element in the lter bottle, please take out the sealing ring and put it in the lter element. Step 4: Flush the system Flush the system by turning on a few cold-water faucets. Allow the water to run until the air and carbon has been purged. -
Page 11: Warranty
Warranty The Waterdrop 2- Stage Whole House Water Filtration System o ers a 1-year warranty covering defects in materials and workmanship from the original date of purchase. During the warranty period, we will replace or repair any part deemed defective, If...