Table of Contents
Advertisement
7. Exhaust port.
At first, some odd odor may be felt while the unit is being used. Assure sufficient ventilation in
the room.
Some heat will leak at the exhaust port even when the unit is operated with the manual
damper closed. When using the unit, be sure to connect a duct for the exhaust port to allow
discharging outside.
See "17. About handling of the exhaust port (manual damper)" on P.8.
8. Installing specimens.
The withstand weight of the included shelf boards is about 15kg. Do not put any specimens
heavier than this. Also, when adding shelf boards, take care not to exceed the total weight of
specimen below.
《Total weight of specimens when shelf boards are installed at all stages》
DKG610(V),DKG650(V)：45Kg or less
DKG810(V),DKG850(V)：75Kg or less
When multiple specimens are placed, place them as dispersed as possible.
Placing too many specimens may prevent proper temperature control. To assure temperature
control precision, put specimens taking care so that at least 30% or more space are assured
on shelf boards.
9. Do not place any specimens on the bottom of inside the bath.
Using the unit with specimens placed directly on the bottom inside the bath may prevent the
unit from exercising its highest performance as well as in-bath temperature may rise
excessively or a malfunction may be caused. Never place any specimens on the bottom
surface.
Place specimens on included shelf boards and put the shelf boards on the shelf pegs.
Putting specimens
on the bottom in
the
bath
foribidden.
10. About recovery from a power outage.
When a power outage occurs during operation and then power is supplied, the unit resumes
operation at the status immediately before the outage.
11. After installation.
The unit may topple down from an earthquake or unexpected shocks and cause a personal
injury.
Implement proper tip-preventive measures for safety.
is
5. Handling Precautions
53
CAUTION
One
shelfboard
is
fixed
at
the
lowest stage.
Advertisement
Table of Contents
