Yamato DKG610 Instruction Manual page 33

MEASURED TEMP.
HEATER
ALARM ℃
AUTO STOP
AUTO START SET
TEMP.
FIXED TEMP.
PROGRAM
OVER TEMP .
PROTECTOR
RUN
ENTER
STOP
FIXED SUB
TIMER PROGRAM
MENU
TEMP.
About the timer function Maximum settable time for the timer is 999 hours 50 minutes.
If you want to correct
wrong settings or to
check settings
About wait action
during the Program
operation
4. Operating Procedures
6.Ending the Program operation
When the Program operation has ended, the buzzer will sound for
about five seconds.
The set temperature indicator displays the character "End" that
means the completion of operation.
Press key to return to the Initial setting screen.
RUN/STOP
Time can be set in the unit of minutes up to 99 hours 59 minutes.
Time period 100 hours and longer shall be set in the unit of 10
minutes.
You can continuously change set time and change to the setting you
want quickly by keeping
keys once at a time to fine adjust a time.
If you want to return to the previous step, for example, to correct a
wrong program or to check settings again, press
to return the Setting screen to the previous one.
Each time you press
FIXED TEMP.
Note：Be sure to perform this operation in the Program Setting
screen.
When a program moves from one step to the next, the next step will
not start if measured temperature has not reached the set
temperature or has exceeded it when the step set time has elapsed.
Note that the unit has been set so that steps will move to the next in
the range of ±3℃ to the set temperature.
30
Creating a program
▽ and △
keys pressed. Press
key, you will go back by one step.
▽ and △
key
FIXED TEMP.