Yamato DKG610 Instruction Manual page 28

MEASURED TEMP.
HEATER
ALARM ℃
AUTO STOP
AUTO START SET
TEMP.
FIXED TEMP.
PROGRAM
OVER TEMP .
PROTECTOR
RUN
ENTER
STOP
FIXED SUB
TIMER PROGRAM
MENU
TEMP.
When you want to
correct a
temperature or a set
time or check settings
3.Stopping and ending the Timer operation
Operation starts automatically when the set time comes.
Press
RUN/STOP
operation. The screen changes to the initial setting screen.
When you want to change the set temperature or the set time during
set operation, press
temperature and the time for the Auto Start operation using
△
keys and then press ENTER key for each setting.
た But when you change the set time, you need to set a time
calculated by adding time period to add to the time already passed.
However, you need to set a time calculated by adding time period to
add to the time already passed when you change the set time.
▽
Pressing key during operation will display the set temperature, the
operation mode, and the remaining time on the set temperature
indicator.
Once the Auto Start time is passed and operation has started, you
cannot change the setting. In this case, use
operation and make settings again.
4. Operating Procedures
Operational steps（Auto Start operation）
key for about one second to stop or end
key without stopping operation, set the
TIMER
25
▽ and
key to stop
RUN/STOP