Yamato DKG610 Instruction Manual page 31

MEASURED TEMP.
HEATER
ALARM ℃
AUTO STOP
AUTO START SET
TEMP.
FIXED TEMP.
PROGRAM
OVER TEMP .
PROTECTOR
RUN
ENTER
STOP
FIXED SUB
TIMER PROGRAM
MENU
TEMP.
MEASURED TEMP.
HEATER
ALARM ℃
AUTO STOP
AUTO START SET
TEMP.
FIXED TEMP.
PROGRAM
OVER TEMP .
PROTECTOR
RUN
ENTER
STOP
FIXED SUB
TIMER PROGRAM
MENU
TEMP.
4. Operating Procedures
② Select a program mode you want and press
・ When you have selected PrG1
temperature indicator displays End
of registered steps flash on the set temperature indicator.
・ When you have selected PrG2
temperature indicator displays PAt
number will flash on the set temperature indicator. Select
pattern "1" or "2" with
Pressing
ENTER
temperature indicator and the number of registered steps
will flash on the set temperature indicator.
・When you have selected PrG3
"2", or "3" with the same procedures as for PrG2.
The program in the example uses up to eight steps, which can be
input for any program mode you select from PrG1, PrG2, or PrG3.
This section describes how to register a program when PrG3 is used
as an example.
4. Registering a program（Inputting a program）
① Select PrG3 following the steps in the previous item 3.
② As per the programming sheet you have filled, input the
number of program steps, step temperatures, and step time.
③ Press
ENTER
displayed when you have selected PrG1. Move to item ⑥.）
④ Use
▽ and △
and PAt3.
⑤ Press
ENTER key. End is displayed and the number of steps
"n" will flash.
※End is a character that indicates the total number of steps to
be used. In the example, you will enter "8".
⑥ Enter the total program step number to use "8" with
△
keys.
⑦ Press
ENTER
the set temperature for the first step will be displayed and the
current set temperature flashes.
⑧ Use
▽ and △
28
▽ and △
keys.
key displays End on the measured
key. Pat number will flash. （ End will be
keys to select a free pattern from PAt1, PAt2,
key. The character Sv-1
keys to set the temperature for the first step.
Creating a program
key.
ENTER
, the measured
and the number
, the measured
and the pattern
, select a pattern "1",
▽ and
that means