Yamato DKG610 Instruction Manual page 20

Operation modes of this unit are as follows.
№
Name
Overheat Preventive
1
function
Calibration Offset
2
function
Overheat Preventive
3 Temperature
Compensation function
Power
4
Compensation function
5 Setting Lock function
List of operation modes and functional menus
Automatic Overheat Preventive function：
The function has been set to automatically activate when
in-bath temperature rises together with the unit set
temperature to a temperature 12℃ plus that temperature
(automatic recovery).
Overheat preventive device：
The power supply unit, the display, and the key input
assembly are common with the controller, while the
device has an independent temperature detecting circuit,
a CPU, sensors, and an output circuit, for which a
temperature you want can be set on the operation panel.
If the overheat preventive device has activated, the unit
will stop and will not recover until the power switch is
turned on again. (Manual recovery).
The Calibration
differences that may occur between the target in-bath
temperature and the temperature on the controller (sensor
temperature).
You can compensate in plus or minus direction over the
entire temperature range of the unit.
When you perform temperature compensation for the
controller in item 2 above, temperature to be input to the
overheat preventive device will also be compensated
automatically.
When a power failure occurred in the middle of operation
Failure and recovered, this function resumes operation at the status
immediately before the failure.
This function is used to lock set operation status.
You can set and cancel lock using the
4. Operating Procedures
Description
Offset function
SUB MENU
17
compensates any
key.
Page
P.19
P.34
－
－
P.35