Yamato DKG610 Instruction Manual page 26

MEASURED TEMP.
HEATER
ALARM ℃
AUTO STOP
AUTO START SET
TEMP.
FIXED TEMP.
PROGRAM
OVER TEMP .
PROTECTOR
RUN
ENTER
STOP
FIXED SUB
TIMER PROGRAM
MENU
TEMP.
When you want to
correct a
temperature or a set
time or check settings
3.Stopping and ending Timer operation
Operation will stop automatically when the set time comes.
The buzzer sounds for about five seconds to tell you that operation
has stopped. At this time, the set temperature indicator display the
character End
Auto Stop lamp is lit. Press
end the Timer operation mode. The screen will switch to the initial
setting screen.
When you want to change the set temperature or the set time during
set operation, press
temperature and the time for the Auto Stop operation using
△
keys and then press ENTER key for each setting.
But you need to set a time calculated by adding time period to add to
the time already passed.
▽
Pressing key during operation will display the set temperature, the
operation mode, and the remaining time on the set temperature
indicator.
The remaining time display
dots are flashing or means wait status (temperature is increasing or
decreasing toward the set temperature) while dots stay lit and the
timer count is stopped.
4. Operating Procedures
Operational steps（Auto Stop operation）
that means completion of operation with the
RUN/STOP
key without stopping operation, set the
TIMER
は means counting down while
23
key for about one second to
▽ and