KVH Industries TracNet H60 Installation Manual page 40

European Union Compliance
Hereby, KVH Industries, Inc. declares that the radio equipment type TracNet H60 complies
with Directive 2014/53/EU. For the full text of the EU Declaration of Conformity, visit
www.kvh.com/euconformity.
Federal Communications Commission Compliance
The TracNet system complies with Class A of Part 15 of the FCC (Federal
Communications Commission) rules for radiated and conducted emissions.
FCC Identifiers: RYK-WNFQ261ACNIBT (TracNet Hub Wi-Fi)
Use Conditions:
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may
cause undesired operation.
Note:
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his or her own
expense. However, there is no guarantee that interference will not occur in a particular
installation. To determine if the equipment is interfering with radio or television reception, remove
or apply power to the equipment and observe if the interference goes away, or returns, when the
unit is off or on. The user is encouraged to try to correct the interference by one of the following
measures:
Reorient or relocate the receiving antenna.
•
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver
is connected.
• Consult KVH for assistance.
IMPORTANT:
To meet FCC requirements, shielded Ethernet cables are required to connect the
•
TracNet Hub or Hub+ to the ship's network.
This equipment contains no user serviceable parts. Opening this unit will violate the
•
warranty and may result in this equipment no longer complying with FCC requirements
for Class A digital devices.
Regulatory Compliance
RYK-WPEQ256ACN (TracNet Hub+ Wi-Fi)
XMR2020RM502QAE (Cellular Radio)