KVH Industries TracNet H60 Installation Manual page 33

TracNet H60 Installation Guide
5. Insert the end of the cable into the #2 end of the 
CST-240 stripping tool. Then rotate the tool clockwise
around the cable until the tool turns easily. This
removes the cable jacket from the end of the cable,
exposing the braid and dielectric.
Figure 59: Stripping the Cable Jacket
Figure 60: Cable Stripped, Exposing Dielectric
6. Using the DBT-U deburr tool, deburr and chamfer the
center conductor. Avoid nicking the aluminum tape
covering the dielectric.
Figure 61: Deburring the Center Conductor
7. Gently flare the braid with your fingers.
Figure 62: Flaring the Braid
Terminating LMR-240 Cable
31