Journal And Receipt Paper-End Detector; Ecr Printer Motor Lock Detector - TEC MA-1595-1 Series Owner's Manual

11. JOURNAL AND RECEIPT PAPER-END DETECTOR

11. JOURNAL AND RECEIPT PAPER-END DETECTOR
(1) This detects when either the journal or receipt paper is coming near the end. It is provided in order to prompt
the operator to replace the old paper roll with a new one.
(2) When the paper roll is out (or the paper has not been set properly), no key operation will be accepted and the
front display will indicate "PAPER END".
(3) When a new paper roll is set, only the [C] key is allowed to operate. Next, when the [C] key is depressed, the
error message "PAPER END" will be cleared and normal key-in operations will be accepted. If any printing
was suspended, it will continue printing.
(4) If this detector senses a paper-end condition during printing, the printing will stop after the current line printing
is completed.
(5) If the [C] key is depressed in the paper-end condition, it will be ignored. The [C] key depression will be
effective to clear the error message only after the new paper roll is set.
(For further details, refer to Chapter 6.)

12. ECR PRINTER MOTOR LOCK DETECTOR

(1) This detects the printer motor lock condition caused by some trouble.
(2) When such a condition is detected, the front display indicates "PRINTER ERROR" and none of the keys
(including [RF] and [JF]) will be accepted.
(3) To regain the normal condition, turn the power of the ECR to OFF, remove the cause of the motor lock, and
then turn the power to ON again.
11. JOURNAL AND RECEIPT PAPER-END DETECTOR
11- 1
EO1-11152