Table of Contents
Advertisement
Sensors Location
Belt Cleaning
1. Ensure the validator is enabled (i.e. Bezel lights are illuminated)
2. Remove Bezel
3. Insert a piece of paper, which is narrower than the width between the two belts, in the
center of the note path to activate the drive motor.
4. Use a lint free cloth dampened with water containing a mild detergent such as dish
detergent and hold it against each drive belt as is turns.
5. Repeat steps 3 and 4 until all dust and debris has been removed from both belts.
6. Repeat step 3 using a DRY lint free cloth to remove any excess moisture.
Manual Go4Platin_en COMPLETE.docx / BG
22
Advertisement
Table of Contents
