Table of Contents
Advertisement
NRI G-13 mft
Acceptor maintenance
The coin validator must only be wiped clean from time to time with a damp cloth (lukewarm
water with some detergent). Beyond that, no further maintenance work is required.
Under no circumstances may the cloth be so wet that fluid runs into the device. Otherwise the
PCB will be damaged.
Do not use any solvents or scouring agents that will attack the plastic material of the device.
1. Pull the machine's mains plug
2. Carefully open the flight deck on the left-hand side and hold it open
3. Use a cloth to wipe off the coin runway inside the coin validator.
4. Close the flight deck again.
5. Reconnect the machine to the mains supply.
Manual Go4Platin_en COMPLETE.docx / BG
15
Advertisement
Table of Contents
